Basic VPN Setup
About Basic VPN Setup
The basic VPN setup sets most parameters to defaults as proposed by the VPN Consortium (VPNC), and assumes a Pre-shared Key, which greatly simplifies setup. After creating the policies through the Basic VPN Setup, you can always update the parameters through the Policies menu.
This VPN Tunnel will Connect to the Following Peers
Gateway
VPN Client
Connection Name and Remote IP Type
New Connection Name
Pre-Shared Key
Endpoint Information
Remote Gateway Type
IP Address
FQDN
Remote WANs IP Address / FQDN
Local Gateway Type
IP Address
FQDN
Local WANs IP Address / FQDN
Secure Connection Remote Accessibility
Remote LAN (Local Network) IP Address
(xxx.xxx.xxx.xxx)
Remote LAN (Local Network) Subnet Mask
(xxx.xxx.xxx.xxx)
Local LAN (Local Network) IP Address
(xxx.xxx.xxx.xxx)
Local LAN (Local Network) Subnet Mask
(xxx.xxx.xxx.xxx)