Administration Access Control

Administration Access Control

You can create an access control list (ACL) that lists up to five IPv4 hosts that are authorized to access the AP management interface by Web, Telnet and SNMP. If this feature is disabled, anyone can access the management interface from any network client by supplying the correct AP username and password.

Field

Description

Management ACL Mode

Enable or disable the management ACL feature. At least one IPv4 address should be configured before enabling Management ACL Mode. If enabled, only the IP addresses you specify will have Web, Telnet, SSH and SNMP access to the management interface.

IP Address (1-5)

Enter up to five IPv4 addresses that are allowed management access to the AP. Use dotted-decimal format (for example, 192.168.10.10).

Note: After you configure the settings, click Apply to apply the changes and to save the settings.

Field	Description
Management ACL Mode	Enable or disable the management ACL feature. At least one IPv4 address should be configured before enabling Management ACL Mode. If enabled, only the IP addresses you specify will have Web, Telnet, SSH and SNMP access to the management interface.
IP Address (1-5)	Enter up to five IPv4 addresses that are allowed management access to the AP. Use dotted-decimal format (for example, 192.168.10.10).