set port membership

Use the set port membership command to dynamically or statically assign membership of a port or range of ports to a VLAN.

set port membership mod_num/port_num {dynamic | static}

Syntax Description

mod_num	Module number.
port_num	Port number.
dynamic	Keyword used to dynamically assign VLAN membership to a port.
static	Keyword used to statically assign VLAN membership to a port.

Default

Default port membership is static.

Command Type

Switch command.

Command Mode

Privileged.

Usage Guidelines

When a port is assigned a VLAN dynamically, the show port command output identifies the VLAN as dynamic and, if the dynamic port is shut down by a VMPS, its status is shown as shutdown.

This command is not supported on the RSM.

This command is not supported by the three-port Gigabit Ethernet switching module (WS-X5403).

Token Ring does not currently support dynamic VLAN membership--all Token Ring ports are static. If you issue a set port membership dynamic command against a Token Ring port, the following message is generated:

Feature not supported for Module x.

Examples

These examples show how to assign VLAN membership to one or more ports using the set port membership command:

Console> (enable) set port membership 3/1-3 dynamic
Ports 3/1-3 vlan assignment set to dynamic.
Spantree port fast start option enabled for ports 3/1-3.
Console> (enable)
Console> (enable) set port membership 4/2 dynamic
Ports 4/1-12 vlan assignment set to dynamic.
Spantree port fast start option enabled for port 4/2.
Console> (enable)
  

Related Commands

set port enable
show port