To enter iom mode, use the scope iom command.
chassis mode scope iom { id | a | b } id
capability mode scope iom vendor model hw-rev
| id |
Module identification number. |
| a |
Specifies switch A. |
| b |
Specifies switch B. |
| vendor |
Vendor name. |
| model |
Model number. |
| hw-rev |
Hardware revision. |
None
Chassis (/chassis)
Capability (/system/capability)
| Release | Modification |
|---|---|
| 1.0(1) |
This command was introduced. |
This example shows how to enter iom mode:
switch-A# scope chassis switch-A /chassis # scope iom 1 switch-A /chassis/iom #
|
Command |
Description |
|
show iom |
|
|
show slot |
|