ip routing multicast holddown

To configure the IPv4 multicast routing initial holddown period, use the ip routing multicast holddown command. To revert to the default holddown period, use the no form of this command.

[ ip | ipv4 ] routing multicast holddown holddown-period

no [ ip | ipv4 ] routing multicast holddown holddown-period

Syntax Description

holddown-
period
Initial route holddown period in seconds. The range is from 90 to 210. Specify 0 to disable the holddown period. The default is 210.

Command Default

The holddown period is 210 seconds.

Command Modes

Global configuration mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Usage Guidelines

To display the holddown period configuration, use this command line:

switch(config)# show running-config | include "ip routing multicast holddown"
 

This command does not require a license.

Examples

This example shows how to configure the routing holddown period:

switch(config)# ip routing multicast holddown 100
switch(config)#

Related Commands

Command
Description
show running-config
Displays information about the running-system configuration.