ip igmp access-group

To enable a route-map policy to control the multicast groups that hosts on the subnet serviced by an interface can join, use the ip igmp access-group command. To disable the route-map policy, use the no form of this command.

ip igmp access-group policy-name

no ip igmp access-group [ policy-name ]

Syntax Description

policy-name
Route-map policy name. The route map name can be a maximum of 100 alphanumeric characters.

Command Default

Disabled

Command Modes

Interface configuration mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Usage Guidelines

The ip igmp access-group command is an alias of the ip igmp report-policy command.

This command does not require a license.

Examples

This example shows how to enable a route-map policy:

switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp access-group my_access_group_policy
switch(config-if)#
 

This example shows how to disable a route-map policy:

switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp access-group
switch(config-if)#
 

Related Commands

Command
Description
show ip igmp interface
Displays IGMP information about the interface.