NX-OS CLI Navigator

To download the initialization string to a modem connected to the console port, use the modem init-string command. To revert to the default, use the no form of this command.

Syntax Description

default	Downloads the default initialization string.
user-input	Downloads the user-input initialization string.

Command Default

The default initialization string is ATE0Q1&D2&C1S0=1\015.

Command Modes

Terminal line configuration mode

Command History

Release	Modification
4.0(0)N1(1a)	This command was introduced.

Usage Guidelines

You can configure the console port only from a session on the console port.

The default initialization string ATE0Q1&D2&C1S0=1\015 is defined as follows:

AT—Attention
E0 (required)—No echo
Q1—Result code on
&D2—Normal data terminal ready (DTR) option
&C1—Enable tracking the state of the data carrier
S0=1—Pick up after one ring
\015 (required)—Carriage return in octal

Use the modem set-string command to configure the user-input initialization string.

Examples

This example shows how to download the default initialization string to the modem connected to the console port:

switch# configure terminal

switch(config)# line console

switch(config-console)# modem init-string default

This example shows how to download the user-input initialization string to the modem connected to the console port:

switch# configure terminal

switch(config)# line console

switch(config-console)# modem init-string user-input

This example shows how to remove the initialization string to the modem connected to the console port:

switch# configure terminal

switch(config)# line console

switch(config-console)# no modem init-string

Related Commands

Command	Description
line console	Enters console port configuration mode.
modem set-string	Configures the user-input initialization string for a modem.
show line	Displays information about the console port configuration.