feature-set fabricpath

To enable a FabricPath feature set, use the feature-set fabricpath command. To disable the FabricPath feature, use the no form of this command.

feature-set fabricpath

no feature-set fabricpath

Syntax Description

This command has no arguments or keywords.

Command Default

None

Command Modes

Global configuration mode

Command History

Release
Modification
5.1(3)N1(1)
This command was introduced.

Usage Guidelines

Note The FabricPath feature is supported only on the Cisco Nexus 5500 Series switches.

You cannot view or access any FabricPath commands until you enable FabricPath on the device.

Note You must install the FabricPath feature set before you enable FabricPath on the switch.

This command requires an Enhanced Layer 2 license.

Examples

This example shows how to enable the FabricPath feature on the switch:

switch# configure terminal
switch(config)# feature-set fabricpath
switch(config)#
 

This example shows how to disable the FabricPath feature on the switch:

switch# configure terminal
switch(config)# no feature-set fabricpath
switch(config)#
 

Related Commands

Command
Description
feature fabric-binding
Enables or disables fabric binding on the switch.
install feature-set fabricpath
Installs the FabricPath feature set on the switch.
show feature-set
Displays the status of the feature.