show interface transceiver fex-fabric

To display information about all transceivers connected to fabric interfaces, use the show interface transceiver fex-fabric command.

show interface transceiver fex-fabric [ calibration | detail ]

Syntax Description

calibration
(Optional) Displays detailed calibration information about the transceiver.
detail
(Optional) Displays detailed diagnostic information about the transceiver.

Command Default

None

Command Modes

EXEC mode

Command History

Release
Modification
4.0(1a)N2(1)
This command was introduced.

Examples

This example shows how to display information about all transceivers that connect to fabric interfaces:

switch# show interface transceiver fex-fabric
Ethernet1/5
sfp is present
name is CISCO-MOLEX INC
part number is 74752-9025
revision is A
serial number is MOC12302468
nominal bitrate is 12000 MBits/sec
Link length supported for 50/125mm fiber is 0 m(s)
Link length supported for 62.5/125mm fiber is 0 m(s)
cisco id is --
cisco extended id number is 4
 
Ethernet1/6
sfp is present
name is CISCO-MOLEX INC
part number is 74752-9025
revision is A
serial number is MOC12260214
nominal bitrate is 12000 MBits/sec
Link length supported for 50/125mm fiber is 0 m(s)
Link length supported for 62.5/125mm fiber is 0 m(s)
cisco id is --
cisco extended id number is 4
<--Output truncated-->
switch#
 

Related Commands

Command
Description
show fex
Displays all configured Fabric Extender chassis connected to the switch.