This COP file provides the means for a 9.1.1 standalone ELM server installation to upgrade to 
10.x or greater standalone PLM software.

The COP file modifies the system so the install/upgrade operation will recognize a PLM
software upgrade file with a version greater than the currently running ELM version.

NOTE:  This is only for 9.1.1 standalone ELM server installations.  This does not affect
       any other deployment type.



Installation Instructions:

It is recommended that you apply this Update during off peak hours. 
 
You can install this COP file from a DVD (local source) or from a computer (remote source)
that the server can access. 
 

Step 1: Download the cop.sgn file
 
Step 2: Copy the file to a writeable CD or DVD or an ftp/sftp server. 

Step 3: Access the Enterprise License Manager by entering the following URL:
 
 http://server-name/elm-admin 
 
 where server-name is the host name or IP address of the admin server. 
 
Step 5: Enter your User Name and Password. 
 
Step 6: Choose Administration > OS Administration:
            - select "Launch Cisco Unified OS Administration utility"
            - log into the "Cisco Unified Communications Operating System Administration"
            - go to Software Upgrades > Install/Upgrade

    -or-

        Choose Administration > Install/Upgrade
 
Step 7: From OS Administration GUI, enter appropriate information and select "Next"

    -or-

        Select "Install/Upgrade Software...", then select DVD/CD or Network radio button,
        enter appropriate information and select "Next"

Step 8: Select the appropriate COP file to install from the list

        OS Administration GUI is a pull-down list, else select the appropriate checkbox


Step 9: From OS Administration GUI, select "Next", wait for the file to download, validate
        download succeeded, validate checksum,
            deedf0354455e4ceb772486985e5cc9e  elm_Elm_v9_1_1_PlmUpgrade.cop.sgn

        and select "Next" again to start the install

    -or-

        Select "Start Installation/Upgrade" to start the install.
 
Step 10: When the installation completes, verify the COP file version using the CLI command
        , show version active, and check that the installed COP file shows in
        "Installed Software Options"