Firmware Version 9.0(3) for Cisco ATA 187

The 9.0(3) firmware image within the installation program supports the Session Initiation Protocol (SIP) for Cisco ATA 187

This firmware version is supported on Cisco Unified Communication Manager Release 7.1.5, 8.0.2 and higher.

Release Notes

For a list of Resolved Problems and Known Problems with this firmware version, you can obtain the Firmware Release Notes in English by clicking the following URL:
http://www.cisco.com/en/US/docs/voice_ip_comm/cata/187/1_0/english/release/notes/atarn903.html

For all ATA documentation, click the following URL:
http://www.cisco.com/en/US/products/hw/gatecont/ps514/tsd_products_support_series_home.html

The Device Enabler

Before using the 9.0(3) firmware for Cisco ATA 187 with Cisco Unified Communication Manager Release 7.1.5, 8.0.2 and higher, you must install the Device Enabler on the Cisco Unified Communication Manager publisher in the cluster.

The 9.0(3) Device Enabler for the ATA 187 is listed below.

Table 1: Cisco ATA 187 Device Enabler

The Firmware Load

Before using the 9.0(3) firmware for Cisco ATA 187 with Cisco Unified Communication Manager Release 7.1.5, 8.0.2 and higher, you must install the latest firmware on all Cisco Unified Communication Manager servers in the cluster.

The 9.0(3) firmware for the ATA 187 is listed below.

Table 2: Cisco ATA 187 Firmware Load

Downloading the Device Enabler and firmware load

Perform the following procedure:

Step 1 Go to the following URL: http://tools.cisco.com/support/downloads/go/Redirect.x?mdfid=278875240  

Step 2 Log in to the Tools and Resources Download Software page.

Step 3 Choose the IP Telephony folder by clicking +.

Step 4 Choose IP Phones > Cisco ATA 180 Series Analog Telephone Adaptors.

Step 5 Choose your ATA type.

Step 6 Choose 9.0(3) under the Latest Releases folder.

Step 7 Download the files listed in Table 1 and Table 2.

Installing the Device Enabler and firmware load

For Cisco Unified Communication Manager Release 7.1.5, 8.0.2 and higher, you must do all software installations and upgrades by using the Software Upgrades menu options. The system can upload and process only software that Cisco Systems approved.

1. Using your web browser, login to the Cisco Unified Operating System Administration web page
2. Under the Software Upgrades menu, select Install/Upgrade.
3. Fill in the appropriate values in the Software Location section for the file you downloaded above, and click Next.
4. In the Options/Upgrades drop-down box, select the file you downloaded above, and click Next.
5. In the File Checksum Details box, verify you have selected the correct firmware and the MD5 has the correct value, click Next.
6. Check that you received a Success message.

Copyright ?/span>2010 Cisco Systems, Inc.  All Rights Reserved