Step 3: Download and Install Cisco Network Assistant

Step 1:   Cisco SMB Support Assistant Site Survey     Step 2:   Hardware Setup Procedure for the Catalyst Switch                   Hardware Setup Procedure for the Catalyst 2955 Switch                   Hardware Setup Procedure for the Catalyst 4500 Series Switch     Step 3:  Download and Install Cisco Network Assistant                       Introduction                       Requirements                       Download CNA                       Next Step                       Troubleshoot the Procedure                       Related Information     Step 4:   Configure the Catalyst Switch with Cisco Network Assistant                   Configure the Catalyst 4500 Series Switch with Cisco Network Assistant

Download PDF   Step 3: Download and Install Cisco Network Assistant    Set Up a Catalyst Switch

Introduction

This document describes how to download and install Cisco Network Assistant (CNA), a PC-based application used to configure Catalyst switches.

Note: If you already have CNA on your computer, you do not need to do this procedure. CNA is located at Start > Programs > Cisco Network Assistant > Cisco Network Assistant.

Back to Top

Requirements

To perform this procedure, you need a Windows PC connected to the Internet. The PC must have these minimum requirements:

• 80 MB of available hard disk space

• Windows 2000 or XP

Back to Top

Download CNA

To download CNA, follow these steps:

1. Go to the CNA home page.

2. Click the link for "free download" from the Download Cisco Network Assistant box.

   

3. When prompted, enter your SMB user name and password, and then click OK.

4. Click on the Network Assistant Installer executable (.exe file).

   

5. When prompted, enter your SMB user name and password again, and then click OK.

6. Read the Encryption Software Export Distribution Authorization form. When you are finished, click the Yes radio button, and then click Submit.

7. Verify the software image that you want to download, and then click Next.

8. Read the Software Download Rules, and then click Agree.

9. When prompted, enter your SMB user name and password again, and then click OK.

10. When the File Download dialog box appears, click Save to download the executable to your desktop.

11. On your PC desktop, double-click the CNA Installer icon to run the installer. Follow the instructions to install CNA on your PC.

Back to Top

Next Step

After you have installed the CNA software, you can use it to configure your switch. Refer to Configure a Catalyst Switch with Cisco Network Assistant.

If you have a Catalyst 4500 Series switch, refer to Configure the Catalyst 4500 Series Switch with Cisco Network Assistant.

Back to Top

Troubleshoot the Procedure

If you have problems with your login or with the CNA download process, contact the SMB Technical Assistance Center (SMB TAC) for assistance.

Back to Top

Related Information

• Configure a Catalyst Switch with Cisco Network Assistant
• Site Survey