The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Can anyone explain why an active account would be listed as having an Inactive status? These are accounts with a recent logon and authentication including successful DUO pushes. It's making it difficult to track those accounts that are actually Inact...
We have a need to send an ERSPAN outside of the fabric to a device that has inline taps attached. Am I correct in assuming that if that device has Layer 3 Endpoint within ACI this is possible? I have configured a POC with a VM that is within the AC...
I'm struggling to understand connectivity problem between a switch and firewall. The Nexus is located between the Core switch and the edge firewall. It's purpose is to divert traffic via ITD for content filtering. My problem right now is that I'm n...
Hi,We have mGRE DMVPN tunnle between one Hub and 7 Spokes. Other 6 Spokes are working fine but one Spoke is not connecting to Hub.Spoke shows DMVPN on IKE state (tunnle is not working) and Hub is not adding nhrp entry in table.Spoke DMVPN TunnelPleas...
Hi, I have a site that has two C9500 as Cores and they have Dell Powerconnect 7024 ver 5.1.18.1 connected with the Core, the issue we are seeing is that the uplinks are not coming seen by the C9500. Just wanted to ask if someone has seen this issue. ...
Dear Community,I'm asking for you guidance. I have come across a challenge on Cisco ASA version 9.8. Need to allow a web server to be access outside(Public) from DMZ Zone to Ouside Zone. Per below configuration template. Nat is transilating but acce...
I have two controllers, one AIR-CT5508-K9 and another Cisco Catalyst 9800-CL, what is happening is the following:The old access points model AIR-AP1832I-Z-K9 only associate with the new 9800 controller, in the old one it associates but does not recei...
Hello friends.I'm working on setting up ISE on Azure for our org. we have combination of domain joined windows clients, IP phones and iPads (Apple products). I have two questions to start the process.1- does ISE Essentials License support Apple produ...
I have successfully enabled PIV authentication for CLI via ISE. However, web does not work, gives me openresty error after entering my PIN. Background - I am with DOI and obtained a certificate for the WLC from the DOI CA. Our PIV cards are provid...
HelloWe have a lot of clients getting the following error when contacting diffrent sites: ERR_SSL_PROTOCOL_ERROR, we have read that SonicWall and Palo Alto also have these problemes. Solution is to turn off "TLS 1.3 Hybridized Kyber Support" in chro...
Hi,So i fired up ACI Simulator using ProxMox Hypervisor.I have set my static IP as follow:IPv4 address: 192.168.1.200/24Gateway: 192.168.1.1the IP address is free and available in my network.The subnet is correct.The gateway is correct.However, i can...
I have registered and have the "Customer Administrator" role and it has been well more than 24 hours (it's been several weeks) since the registration completed, yet I cannot use the portal. When I sign in, it tells me that I don't have access and ne...
Hi we have 2 WSA out of which one WSA is showing 503 error for a specific Site. When i tried nslookup in WSA for that site it shows the server returned no data(in both WSA).But the site is working in one WSA but not in the other and after 15 mins the...