The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
I have an 8000-series router running IOS XR. I need SNMPv2 to work, but by default that enables SNMPv3. I need to explicitely disable SNMPv3 without disabling SNMPv2.ACLs don't seem to work on the SNMPv2 configuration line. ACL'ing the physical in...
Our company is implementing 802.1x on our network. When a device auth fails it is moved to our guest vlan. I need to prevent any communication from one device to another within the vlan and only allow outbound communication. I am sure there are many ...
We recently moved to a SIP trunk and inbound/outbound calls worked just fine, but DTMF is not functioning for SCCP phones. When a call is made and we get an auto-attendant (using a SCCP phone), when selecting an option, the selected option is not reg...
Hi Together, i'm having problems with configuring BLF on 8851 3PCC with Asterik System. BLF are blinking and when pressed i've getting failure "Invalid Number". Software Version: sip88xx.11-0-1MPP-477.loads Voice with no problems, Calls possible ...
Hi, community,I have some doubts about the feature Root Guard. My scenario is four VLANs on two distribution switches and some access switches connected to the upper layer. Switch A is the root bridge for VLANs 1 and 2, while Switch B is the root bri...
Hi, i have problem of synced betewin my 2 switchs nexus 7.0.3.i7.3I use feature BGP, LACP and VRRP (also VPC etc..)But it's impossible of configure correctly the protocolI have many errors :One : In log :%ETHPORT-3-IF_ERROR_VLANS_SUSPENDED: VLANs 9-1...
I have been working on setting up ISE with an Aruba IAP running version 6.5.4.2 and ran into an issue that I think should be noted in the config guide published on cisco.com for configuring Aruba with ISE flow:Configure Guest Flow with ISE 2.0 and Ar...
Hi TeamNeed help with files uploaded to cisco ise repository. All settings related to FTP and file permission done but yet couldn't access files in the repository. See below error message: XP-ISE-02/admin(config)# repository ftp-repoXP-ISE-02/admin(c...
Monitorar aplicações distribuídas é fundamental, mas vamos ser honestos: lidar com uma avalanche de dados de telemetria pode ser uma dor de cabeça. Quer seja em termos de desempenho ou de custo, gerenciar esses dados não é moleza. Grandes volumes de ...
Hello Folks, I have a pair of ASA5516 with HA mode, ISP provides a high-speed WAN 500Mbps up/download, while doing some speed tests recently we noticed that all our tests from the inside network are not bypassing 100mbps, I checked all inside/outside...
Hi Guys.We are running Firepower 3140 Appliances. There are 2 * 40Gbps connection. The Physical (ETH2/1) 40Gbps interface has the MTU set as 9000 whilst the Sub Interface (ETH2/1.10) and (ETH2/1.20) has the MTU still at 1500In this scenario,1. Is the...
Hi, as the title says, I am unable to connect to my Cisco Secure VPN after updating my OS from Ubuntu 22.02 to 24.04. The error I receive is"You are missing the required libraries for the authentication method you requested."Upon closer inspection, t...