The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
I'm trying to write a python script that will help me with a project that I'm working on and I'm confused about what to do after I've logged into the APIC (stored my APIC-Cookie that I get in the initial login prompt). On subsequent requests, using ...
I'm having a quandary with temperatures on switches. The data sheet for these devices state that the max operating temp is 45-55C. Yet, I get an output like this: OR227-XW1>sho env tempSwitch 1: SYSTEM TEMPERATURE is OKInlet Temperature Value: 46...
I have been using an RV320 Gigabit Dual WAN VPN Router for several years now in a simple modem->router->switch configuration, and around the start of August I began noticing a few websites began timing out when I tried to access them. For example, I ...
I have a controller which is very slow to respond via web GUI and I suspect that maybe one or more devops or ops teams is hammering it with API calls. Is there a way to quickly determine how much of the system resources are getting consumed by API c...
I have a AIR-AP1815W-B-K9 that can't join my 5520 controller. What's weird is that it joined on my test switch in office. When I bring it to the edge switch, it won't join.....switch config is all correct. POE etc is all correct.I attached the log of...
Hi Everybody,I am studying for Cisco and Microsoft certifications and I am doing a practical bit in my own home network. Here is the scoop, I have 3 Cisco rack mounted routers and 3 Cisco rack mounted switches. I also have a Windows 2012 Server runni...
HiI have 2 x Firepower 2110 ASA Transparent mode Firewalls connected to each other. The Firewall are used to create 3 levels of Security Zones for Servers. Layer 3 will collect updates from the internet. Layer 3 will then copy the updates to Server i...
Looking for information. Is it possible to connect and control devices from codec. Need to send on/off and channel strings to tuners and tvs. I'm assuming macros make it possible but I am struggling to find anything on this. In the past I have us...
I have Cisco UCS 5108 and trying to install Cisco UCS 6324 Fabric Interconnect for the configuration purposes. I can't boot it normally. it's give ma message of non-supported.
Join the Webex Developer team on May 15th at 7am PT to learn about the capabilities of the Webex Web Calling SDK designed to enhance your application's direct communication capabilities. Learn how to effortlessly integrate fundamental audio calling c...
Trying to follow DISA SRGs, and one of the requirements is to enable FIPS mode on our 2140 FTDs, managed by FMC. I am new to these so was doing some searching online and it sounds like CC compliance is what needs to be enabled.Am I correct in saying ...
I have created a tunnel-te from xrv16 to csr3, the tunnel is up and getting Pop label to csr3 that's ok.From xrv16 I have learned the route to xrv17 over the tunnel, but checking the Label it's unlabbled as well.I believe the route from xrv16 to xrv1...
I'm confused about something and I'd like your help in understanding. Where I work, we have a router that's connected to 2 ISPs via BGP. Weight is set to 100 to ISP-A and 50 to ISP-B so outbound traffic is going through ISP-A and AS-Path prepend is m...