There are no specific requirements for this document.
The information in this document is based on Cisco IOS® Release 11.3.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
The following commands control the timeout for the login sequence prompts (username, password). If you dial in via async and run a script that shows the username and password provided by the Cisco router, you may need to extend the 30-second default.
tacacs-server login-timeout [seconds] !--- Original version. timeout login response [seconds] !--- Updated version.
The commands are functionally identical. The command syntax was first changed in Cisco IOS Releases 11.3(4), 11.3(4)T, 11.3(4)WA4, and 12.0(1).
Original command syntax:
isdn2-2(config)#tacacs-server login-timeout ? <1-300> Max seconds to wait isdn2-2(config)#tacacs-server login-timeout 300
Current command syntax:
isdn2-2(config-line)#timeout login response ? <0-300> Timeout in seconds isdn2-2(config-line)#timeout login response 300
Note: The original command was global. The current (updated) command is a line configuration command.
The default time between username prompts is 30 seconds. If you set the time to 60 seconds, the client will be prompted every 60 seconds, for a maximum of three times, if no user input is detected. The commands are not Terminal Access Controller Access Control System (TACACS) dependent—you do not need to run TACACS or any authentication, authorization, and accounting (AAA).
The original command was renamed through CSCdj20257.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.