Document ID: 64078
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Configurations
Verify
Troubleshoot
NetPro Discussion Forums - Featured Conversations
Related Information
Introduction
This document provides a sample configuration for Qualified Logical Link Control (QLLC) to reverse Synchronous Data Logical Link Control (SDLLC).
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Configure
This section presents you with the information you can use in order to configure the features this document describes.
Note: In order to find additional information on the commands this document uses, use the Command Lookup Tool ( registered customers only) .
Configurations
This document uses these configurations:
|
Router A |
|---|
source-bridge ring-group 100 source-bridge remote-peer 100 tcp 1.0.0.1 source-bridge remote-peer 100 tcp 5.0.0.1 interface serial 0 encaps x25 x25 address 311901001 x25 map qllc 4000.3745.00C1 311901002 x25 map qllc 4000.3745.00C2 311901002 x25 npsi-poll 4000.3745.00C1 x25 npsi-poll 4000.3745.00C2 qllc srb 4000.3745.00C1 200 100 qllc srb 4000.3745.00C2 200 100 interface serial 1 ip address 1.0.0.1 255.255.255.0 encaps x25 x25 address 311040001001 x25 map ip 5.0.0.1 311040001002 |
|
Router B |
|---|
source-bridge ring-group 100 source-bridge remote-peer 100 tcp 1.0.0.1 source-bridge remote-peer 100 tcp 5.0.0.1 interface serial 0 encaps x25 ip address 5.0.0.1 255.255.255.0 x25 address 311040001002 x25 map ip 1.0.0.1 311040001001 interface serial 1 encaps sdlc sdllc traddr 4000.3174.0000 400 1 100 sdlc address C1 sdlc address C2 sdllc partner 4000.3745.00C1 C1 sdllc partner 4000.3745.00C2 C2 sdllc xid C1 017010C1 sdllc xid C2 017010C2 |
Notes:
-
Requires exchange identification (XID) from a LAN-attached device in order to initiate a session.
-
The IP routing configuration is not shown. The assumption is that the IP routing configuration runs properly.
-
Clocking is also required by the DCE device (not shown in these configurations).
Verify
There is currently no verification procedure available for this configuration.
Troubleshoot
There is currently no specific troubleshooting information available for this configuration.
NetPro Discussion Forums - Featured Conversations
| NetPro Discussion Forums - Featured Conversations for IBM |
| Network Infrastructure: Enterprise Data Centers |
Related Information
| Updated: Sep 09, 2005 | Document ID: 64078 |