Document ID: 20766
Contents
Introduction
Before You Begin
Conventions
Prerequisites
Components Used
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Related Information
Introduction
This document provides a sample configuration for Advanced Peer-to-Peer Networking (APPN) over PPP multilink connections.
Before You Begin
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.
Prerequisites
There are no specific prerequisites for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information presented in this document was created from devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If you are working in a live network, ensure that you understand the potential impact of any command before using it.
Configure
In this section, you are presented with the information to configure the features described in this document.
Note: To find additional information on the commands used in this document, use the Command Lookup Tool (registered customers only) .
Network Diagram
This document uses the network setup shown in the diagram below.
Configurations
This document uses the configurations shown below.
|
RouterA |
RouterB |
|---|---|
hostname RouterA username RouterA password 7 86428642 username RouterB password 7 97531975 interface Serial0 encapsulation ppp no keepalive dialer in-band dialer idle-timeout 30 dialer rotary-group 1 pulse-time 1 interface Serial1 no ip address encapsulation ppp no keepalive dialer in-band dialer idle-timeout 30 dialer rotary-group 1 pulse-time 1 interface Dialer1 ip address 1.1.1.1 255.255.255.0 encapsulation ppp dialer in-band dialer idle-timeout 30 dialer map llc2 name RouterB dialer map ip 1.1.1.2 name RouterB dialer load-threshold 1 either dialer-group 1 ppp multilink ppp authentication chap appn control-point NETA.ROUTERA complete appn port DIAL Dialer1 complete appn link-station ROUTERB port DIAL complete dialer-list 1 protocol ip permit dialer-list 1 protocol llc2 permit |
hostname RouterB username RouterB password 7 97531975 username RouterA password 7 86428642 interface Serial0 encapsulation ppp no keepalive dialer in-band dialer idle-timeout 30 dialer rotary-group 1 pulse-time 1 interface Serial1 no ip address encapsulation ppp no keepalive dialer in-band dialer idle-timeout 30 dialer rotary-group 1 pulse-time 1 interface Dialer1 ip address 1.1.1.2 255.255.255.0 encapsulation ppp dialer in-band dialer idle-timeout 30 dialer map ip 1.1.1.1 name RouterA dialer map llc2 name RouterA dialer load-threshold 1 either dialer-group 1 ppp multilink ppp authentication chap appn control-point NETA.ROUTERB complete appn port DIAL Dialer1 complete appn link-station ROUTERA port DIAL complete dialer-list 1 protocol ip permit dialer-list 1 protocol llc2 permit |
Verify
The verification commands are included in the configurations above.
Troubleshoot
The troubleshooting commands are included in the configurations above.
Related Information
| Updated: Sep 09, 2005 | Document ID: 20766 |