IBM SNA Networking

Document ID: 12302

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Configure
      Network Diagram
      Configurations
Verify
Troubleshoot
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This sample configuration demonstrates Qualified Logical Link Control (QLLC) to Synchronous Data Link Control (SDLC) via data-link switching (DLSw).

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Configure

In this section, you are presented with the information to configure the features described in this document.

Note: Use the Command Lookup Tool ( registered customers only) to find more information on the commands used in this document.

Network Diagram

This document uses this network setup:

Configurations

This document uses these configurations:

source-bridge ring-group 100
dlsw local-peer peer-id 10.255.2.1
dlsw remote-peer 0 tcp 10.255.1.1
!
interface Loopback0
ip address 10.255.2.1 255.255.255.0
!
interface Serial2
no ip address
encapsulation sdlc
bandwidth 4800
no keepalive
clockrate 4800
sdlc role primary
sdlc vmac 4000.2520.0100
sdlc address C1
sdlc xid C1 0C112345
sdlc partner 4000.6000.1000 C1
sdlc dlsw C1

!
source-bridge ring-group 100
dlsw local-peer peer-id 10.255.1.1
dlsw remote-peer 0 tcp 10.255.2.1
!
interface Loopback0
ip address 10.255.1.1 255.255.255.0
!
interface Serial2
no ip address
encapsulation x25 dce ietf
no ip mroute-cache
x25 address 60002000
x25 htc 100
x25 suppress-called-address
x25 suppress-calling-address
x25 map qllc 4000.6000.1000 60001000
clockrate 56000
qllc dlsw subaddress 031847 vmacaddr 4000.6000.1000 partner 4000.2520.01C1 
! 

Verify

There is currently no verification procedure available for this configuration.

Troubleshoot

There is currently no specific troubleshooting information available for this configuration.

NetPro Discussion Forums - Featured Conversations

Related Information

• Technical Support & Documentation - Cisco Systems