IBM Networking

Document ID: 12341

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Configure
      Network Diagram
      Configurations
Verify
Troubleshoot
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document provides a sample configuration for data-link switching (DLSw) with local and remote source-route translational bridging (SR/TLB).

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Configure

In this section, you are presented with the information to configure the features described in this document.

Note: Use the Command Lookup Tool ( registered customers only) to find more information on the commands used in this document.

Network Diagram

This document uses this network setup:

Configurations

This document uses these configurations:

• Router A

• Router B

hostname RouterA

source-bridge ring-group 31
source-bridge transparent 31 25 1 5
dlsw local-peer peer-id 128.207.2.155
dlsw remote-peer 0 tcp 128.207.1.145
dlsw bridge-group 5
 
interface Ethernet0
 ip address 128.207.111.1 255.255.255.0
 bridge-group 5
 
interface Serial0
 ip address 1.1.1.1 255.0.0.0
 
interface TokenRing0
 ip address 128.207.2.155 255.255.255.0
 ring-speed 16
 source-bridge 200 1 31
 source-bridge spanning
 
bridge 5 protocol ieee

hostname RouterB

source-bridge ring-group 31
dlsw local-peer peer-id 128.207.1.145
dlsw remote-peer 0 tcp 128.207.2.155

interface TokenRing0
 ip address 128.207.1.145 
 ring-speed 16
 source-bridge 300 1 31
 source-bridge spanning

interface Serial0
 ip address 1.1.1.2 255.0.0.0

Note: A source-bridge transparent statement is not needed to make a link between the Ethernet and the virtual ring domain. The dlsw bridge-group 5 command makes this link.

Note: The source-bridge transparent 31 25 1 5 statement is needed to accommodate bridging between local interfaces.

Verify

There is currently no verification procedure available for this configuration.

Troubleshoot

There is currently no specific troubleshooting information available for this configuration.

NetPro Discussion Forums - Featured Conversations

Related Information

• Troubleshooting DLSw
• DLSw Support Page
• Technical Support & Documentation - Cisco Systems