Configuring IOCP from a 9221 Mainframe

Document ID: 12306

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Configure
      Sample IOCP
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document provides information on configuring an Input/Output Configuration Program (IOCP) from a 9221 mainframe.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

This is a sample IOCP from a mainframe running Virtual Machine (VM). This mainframe contains a number of devices. Most of this IOCP has been deleted. The last three statements define a Channel Interface Processor (CIP) attached to this host via an Enterprise System Connection (ESCON) channel and through an ESCON DIRECTOR.

ID MSG1='IOCP9033',                                                   X 
                     SYSTEM=(9221,1)                                 

*IXP  IXP157I SYSTEM=(9221,1) USED BY IOCP
                               

*** ---- I/O CONTROLLER - 6120 - AT CHANNEL - 00 -
                    
 CHPID PATH=((00,00,0)),TYPE=IOC                                        
 CNTLUNIT CUNUMBR=0C00,PATH=(00),SHARED=Y,                             * 
               UNITADD=((00,032)),                                     * 
               UNIT=6120                                                   
 IODEVICE ADDRESS=(0000,032),CUNUMBR=(0C00),UNITADD=00,                * 
               UNIT=6120                                          

*** ---- I/O CONTROLLER - 6310 - AT CHANNEL - 0C -
              
 CHPID PATH=((0C,0C,0)),TYPE=IOC                                       
 CNTLUNIT CUNUMBR=0C01,PATH=(0C),SHARED=N,                             * 
               UNITADD=((00,016)),                                     * 
               UNIT=6310                                               
 IODEVICE ADDRESS=(0C00,002),CUNUMBR=(0C01),UNITADD=00,                *
               UNIT=9332,MODEL=60                                   
 CNTLUNIT CUNUMBR=0C02,PATH=(0C),SHARED=N,                             *
               UNITADD=((10,016)),                                     * 
               UNIT=6310                       
 IODEVICE ADDRESS=(0C10,002),CUNUMBR=(0C02),UNITADD=10,                *
               UNIT=9332,MODEL=60                                     
 CNTLUNIT CUNUMBR=0C03,PATH=(0C),SHARED=N,                             *
               UNITADD=((20,016)),                                     *
               UNIT=6310                                                 
 IODEVICE ADDRESS=(0C20,002),CUNUMBR=(0C03),UNITADD=20,                * 
               UNIT=9332,MODEL=60                                             

 
****** Generated Source End ******
                                           
 CHPID PATH=((27)),TYPE=CNC,SWITCH=02                                          
 CNTLUNIT CUNUMBR=001B,PATH=(27),UNIT=3088,UNITADD=((E0,32)),LINK=(C6)         
 IODEVICE ADDRESS=(07E0,32),CUNUMBR=(001B),UNIT=CTC

NetPro Discussion Forums - Featured Conversations

Networking Professionals Connection is a forum for networking professionals to share questions, suggestions, and information about networking solutions, products, and technologies. The featured links are some of the most recent conversations available in this technology.

NetPro Discussion Forums - Featured Conversations for IBM

Network Infrastructure: Enterprise Data Centers

Related Information

Updated: May 31, 2006

Document ID: 12306

Hierarchical Navigation

IBM CIP Protocols