Cisco Unified Communications Manager (CallManager)

Document ID: 82045

Feedback

This series of interactive documents uses a typical head office and branch office in order to demonstrate some common voice network configurations. This interactive diagram allows you to view network configurations:

This image is interactive! Click a component to view configuration and troubleshooting information.

Refer to Unified CallManager Interactive Voice Network Configuration and Troubleshooting Case Study for requirements assumed by this series of interactive documents.

Configure

This section describes the Manager phone configurations for the RTP location. For more information on these configurations, see Introduction.

In order to configure phones for the RTP location, complete these steps:

1. Configure the parameters as shown in this image:
   
   
   
   
2. Configure the Directory Number ( DN ) as shown in this image:
   
   
   
   Note: Only the 4003 DN is shown in this image.