This document describes one reason why Cisco CallManager fails to communicate with the Avaya Unified Messaging System via the Cisco VG224 Voice Gateway by using the Simplified Message Desk Interface (SMDI) protocol. This document also provides a solution.
Cisco recommends that you have knowledge of these topics:
Cisco VG224 Voice Gateway
Avaya Unified Messaging System
The information in this document is based on these software and hardware versions:
Cisco CallManager 4.x
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
A problem exists when Cisco CallManager communicates with the Avaya Unified Messaging System across the serial port by using an SMDI protocol such as Message Waiting Indicator (MWI) refresh / resynch.
In the corresponding trace, it is identified that the Cisco Messaging Interface (CMI) service does not receive the SsInfoInd signal from Cisco CallManager. Therefore, the subsequent signaling stops because CMI does not generate SMDI messages.
This output shows the corresponding error message on the Avaya Unified Messaging System:
failed to get integration data
Figure 1 shows the topology of the problem.Figure 1—CallManager and Legacy Voice Mail Integration with SMDI through VG224
This problem is a configuration issue. When you configure individual port 2/0 of the Cisco VG224 Voice Gateway for the SMDI port number, it is wrongly configured as 0 (see arrow A in Figure 2). The SMDI port number for the VG224 gateway in Cisco CallManager needs to be set to a value greater than 0 in order to enable the SMDI protocol. Otherwise, the gateway end point does not send the initiation message. The beginning number needs to be 1 instead of 0. This is the root of the problem.Figure 2—SMDI Port Number
This table shows the SMDI port numbers and the corresponding ports on the Cisco VG224 Voice Gateway:
|VG224 Port||SMDI Port Number|
In order to solve the problem, complete these steps to modify the SMDI port number:
Select Device > Gateway to display the Find/List Gateways window.
Click Find to display all the gateways.
Click the correct VG224 Voice Gateway to display the Gateway Configuration window.
Scroll to the Installed Voice Interface Cards section.Figure 3—Installed Voice Interface Cards
Click 2/0 (see arrow A in Figure 3) under the Endpoint Identifiers section.
Scroll to the port information (see Figure 2) through the new displayed window.
Enter 1 in the SMDI Port Number (0-4096) field.
Repeat step 5 through 7 in order to configure ports 2/1 through 2/23 with the matching number as Table 1 shows.
Reset the Cisco VG224 Voice Gateway through Cisco CallManager.
Reboot the Cisco VG224 Voice Gateway.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.