Cisco Unified Communications Manager (CallManager)

Document ID: 23303

PDF Downloads Installation of Attendant Console Prevents Cisco CRA 2.x From Starting

Feedback

Introduction

Sites that have the Cisco Customer Response Application (CRA) 2.x co-located with Cisco CallManager has issues with the start of the Application Engine if the new Attendant Console 1.x is installed on the same server.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on CRA 2.x.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Problem

Any application hosted by the CRA server does not work. Cisco IP AutoAttendant, IP-ICD, and Extension Mobility are some of the most common applications that run on the Apps server.

The Engine Status page (http://ipaddress/appadmin) shows the SubSystems as "Unavailable" as shown here.

For more information about the Attendant Console, see: Cisco Unified Communications Manager Attendant Console.

Solution

Change the RMI Port on the Apps server to use something other than 1099 (for example, 1098). Follow these steps to change the RMI Port:

1. Log in to the Application Administration web page (http://ipaddress/appadmin). Click Engine, then click Configure.

2. Change the RMI Port Number to 1098.

   Figure 2: Application Administration -- Change RMI Port Number

   

3. Click Status.

4. Click Stop.

5. Start the Engine.

6. Click Start > Progams > Administrative Tools > Services.

7. Find the World Wide Web Publishing Service and the Restart.

   Figure 3: Services

   

Cisco Support Community - Featured Conversations

Related Information

• Cisco Unified Communications Manager Attendant Console
• Voice Product Support
• Voice and Unified Communications Technology Support
• Voice Software
• Troubleshooting Cisco IP Telephony
• Technical Support & Documentation - Cisco Systems