Document ID: 10918
This problem can be caused by the failure to configure a codec on the dial-peer for a device that places calls over the dial peer. In the example in this document, a device that requires g711ulaw attempts to make a call over a dial peer. The call fails and the caller hears a busy tone.
This first section of this document shows you the Cisco CallManager error message trace for this problem. The second section shows the configuration with a pointer to the missing command. The third section explains how to configure the voice class codec command in order to support multiple codecs on the same dial peer.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Cisco CallManager|H245Interface(30) - match capabilities failed Cisco CallManager|AgenaInterface - ERROR waitForMXCapabilitiesExchanged_MediaExchangeCapabilitiesIncoming - match capabilities error
If you need help setting up traces for the TAC, refer to Setting up CallManager Traces for the TAC.
! dial-peer voice 2000 voip destination-pattern 2... session target ipv4:10.10.10.10 dtmf-relay cisco-rtp h245-signal h245-alphanumeric ip precedence 5 !
Note: This configuration does not have the codec g711ulaw command under the dial-peer. By default, the dial-peer uses g729r8 compression. Any devices that do not use g729r8 compression are not able to complete the call.
In order to fix this, add the codec g711ulaw command under the dial-peer.
In some cases it is necessary to support multiple codecs on a dial peer. Different regions or devices might use different codecs. For example, WAN connections between routers use g729, while Cisco Unity servers use g711 by default. If we know that a call must traverse regions that use different codecs or need to integrate devices that require different codecs, then we need to make sure the dial-peer supports multiple codecs. This section explains how to configure multiple codecs for one dial-peer.
Router#configure terminal Router(config)#voice class codec 99 Router(config-class)#codec preference 1 g711ulaw Router(config-class)#codec preference 2 g729br8 Router(config-class)#codec preference 3 g729r8 Router(config-class)#end Router(config)#dial-peer voice 2000 voip Router(config-dial-peer)#voice-class codec 99 Router(config-dial-peer)#^Z
When you invoke the parser help when you enter codecs under the voice-class, it shows a list of the codecs supported by your router.
AV-3640-1(config-class)#codec preference 3 ? clear-channel Clear Channel 64000 bps g711alaw G.711 A Law 64000 bps g711ulaw G.711 u Law 64000 bps g723ar53 G.723.1 ANNEX-A 5300 bps g723ar63 G.723.1 ANNEX-A 6300 bps g723r53 G.723.1 5300 bps g723r63 G.723.1 6300 bps g726r16 G.726 16000 bps g726r24 G.726 24000 bps g726r32 G.726 32000 bps g728 G.728 16000 bps g729br8 G.729 ANNEX-B 8000 bps g729r8 G.729 8000 bps gsmefr GSMEFR 12200 bps gsmfr GSMFR 13200 bps
- Unity Installation and Troubleshooting: G.729a Codec
- VoIP - Understanding Codecs: Complexity, Support, MOS, and Negotiation
- Voice Technology Support
- Voice and Unified Communications Product Support
- Troubleshooting Cisco IP Telephony
- Technical Support & Documentation - Cisco Systems
|Updated: Jan 20, 2006||Document ID: 10918|