This document describes how to solve the problem of when Cisco Unity does not record voicemail that is more than 50 seconds when connected through a Media Gateway Control Protocol (MGCP) gateway.
Cisco recommends that you have knowledge of these topics:
Cisco IOS® MGCP voice gateway
The information in this document is based on these software and hardware versions:
Cisco Unity 4.0
Cisco IOS Voice gateway 3825
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Cisco Unity stops to recording the voice message , after about 50 seconds due the disconnect of call through MGCP gateway . Even though the maximum message length on the subscriber page is set to 420 seconds and the maximum message length in the COS is 300 seconds. The maximum message length in Cisco Unity tools is set to 1200 seconds.
If there is no VoIP activity in the MGCP gateway, after the defined receive-rtcp timer, the gateway tries to disconnect the call and this stops the recording of the voice message in the Cisco Unity Server.
The receive-rtcp is the timer used by a gateway to disconnect a VoIP call when IP connectivity is lost with the remote gateway. After it receives each RTP or RTCP packet from the remote gateway, the receiving gateway starts a timer. The period of the timer is determined by the multiplication of the value configured with the mgcp timer receive-rtcp command, with the value configured with the use of the ip rtcp report interval command. If the timer expires before the next packet is received from the remote gateway, the receiving gateway disconnects the call and notifies the call agent.
Cisco Unity is unable to record messages for more than 50 seconds because the receive-rtcp timer times out on the MGCP gateway and the call gets disconnected. Disable the timer with these commands in the MGCP gateway in order to solve the problem due to disconnect of the call.
MGCPGateway(config)#no mgcp timer receive-rtcp
This command turns off the RTP RTCP receive timeout interval at the MGCP gateway.
MGCPGateway(config)#voice rtp send-recv
This command is used in order to establish a two-way voice path when the Real-Time Transport Protocol (RTP) channel is opened.
You are unable to change the subscriber message length to one hour and when you use live record, you can only leave a short recording message.
Complete these steps in order to resolve this issue:
Go to the Cisco Unity SA web page and click Subscribers. Search and find the the user for which you want to set the subscriber message length to one hour. Choose Messages and set the Maximum Message length, in seconds: to 3600.
Choose Cisco Unity Tools Depot > Administrative Tools > Advanced Settings Tool, choose Conversation - set maximum recording time and set it to 3600000. This value is stored in milliseconds and can go up to one hour (3,600,000 milliseconds).
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.