Rx FIFO (first-in-first-out) sync errors indicate that the receive FIFOs used by the BIF-RX circuit either got out of sync with the start of frames or with each other.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
Refer to the Cisco Technical Tips Conventions for more information on document conventions.
These errors mean that two frames have been discarded. However, those frames did not necessarily contain any user data (it is possible that these frames were fillers known as Null BFrames). When these errors occur infrequently, the errors are simply counted. If the errors happen too often, a hardware error is generated because a circuit failure can cause them.
Make sure you use the latest firmware. If the errors continue, replace the card.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.