This document describes the basic categories of slot errors on the Cisco BPX and provides an approach to resolve the errors within each category.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
There are two basic categories of slot errors on the BPX:
Error resolution within each category is similar. Many of the slot errors occur with shared resources. If the Broadband Controller Card (BCC) or the bus has a problem, all the cards in the shelf can indicate the same problem. If only one card indicates a problem, that card is likely the card with the failure.
Point-to-point errors are more difficult to isolate because the paths are dedicated, unique to each connection. The paths consist of:
Card that transmits
Backplane from this card to the BCC
BCC with the crosspoint switch
Backplane to the card that receives
Card that receives
Through the careful swap of cards, you can isolate the problem to the card with the failure. Most of the cards collect the slot errors with a 100-millisecond task. This collection limits the maximum rate of any error to 100 during any of the 10-second poll periods that the system software uses. In order to enable the software collection, issue the on2 9 command and the on2 10 command. In order to enable an alarm on slot error conditions, issue the on2 2 command. In some software releases, a bug causes the double count of each error, so the maximum rate is 200 within 10 seconds.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.