Cisco VCO/4K Open Programmable Switches

Document ID: 15269

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Configuration Changes
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document explains the configuration changes on the VCO4K reboot.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on all versions of VCO Generic.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Configuration Changes

When the VCO 4K is rebooted, these configurations are lost and need to be reconfigured once the VCO reboots.

• Any cards that were taken Out Of Service (O), Maintenance (M), Diagnostics (D) or Remote (R) by the user in Card Maintenance. After reboot they become Active/Maintenance.

• Any paths that were set up using Set Up Path under the Diagnostics menu are lost and need to be set up again.

NetPro Discussion Forums - Featured Conversations

Related Information

• Voice Technology Support
• Voice and IP Communications Product Support
• Recommended Reading: Troubleshooting Cisco IP Telephony
• Technical Support - Cisco Systems