ASP Specifications

The LightStream 1010 ATM switch processor (ASP) specifications are described in Table B-1.

For the LightStream 1010 ATM switch chassis and common equipment specifications, refer to the appendix "System Chassis Specifications" in the LightStream 1010 ATM Switch Hardware Installation Guide. For port adapter module (PAM) specifications, refer to the appendix "CM and PAM Specifications" in the LightStream 1010 ATM Switch PAM Installation Guide.

Table B-1: ASP Specifications

Description	Specifications

Switch and processor capacity	5-Gbps shared memory, nonblocking switch fabric 65,536 cells of ATM cell buffers
Software images	Default image with PNNI¹
Dimensions (H x W x D)	ASP: 1.2 x 14.4 x 16 in. (3.0 x 36.6 x 40.6 cm)
Weight	6.85 lb (3.09 kg)
DC voltages supplied and steady-state maximum current ratings	System: +5V @ 70A +12V @ 2A +24V @ 0.2A ASP: +5V @ 15A +24V @ 25mA +12V @ 500mA
Operating temperature	32 to 104ºF (0 to 40ºC)
Nonoperating temperature	-40 to 167ºF (-40 to 75ºC)
Humidity	10 to 90%, noncondensing
Altitude	-500 to 10,000 ft. (-52 to 3048 m)
Microprocessor	100-MHz MIPS² R4700
Memory	8-MB Flash memory SIMM (upgradable to 16 MB) 32-MB DRAM³ default for FC-PCQ⁴ (upgradable to 64 MB) and 64-MB DRAM default for FC-PFQ⁵ 256-KB boot EPROM⁶ 128-KB SRAM⁷ No Flash memory (PCMCIA⁸) card installed by default (accepts 8-, 16-, or 20-MB Intel Series 2+ Flash memory cards)
Interface timing	Loop timing, Stratum 4 accuracy clock for self-timing, master clock distribution port
Management access	Standard Ethernet and dual EIA/TIA-232⁹ serial ports on the ASP
Connections	32,000 point-to-point, 2048 multi-to-multipoint VC¹⁰ and VP¹¹ switching, VP tunneling PVC¹² and SVC¹³ F4 and F5 OAM¹⁴ segment and end-to-end flows, RDI¹⁵ and AIS¹⁶ OAM PING on IP or ATM address
Interface ports	RJ-45 IEEE¹⁷ 802.3 Ethernet 10BaseT port DB-25 EIA/TIA-232 auxiliary port and a DB-25 console port for an administration workstation
Network management	Port TX¹⁸ and RX¹⁹ LEDs²⁰, switch and common equipment status LEDs Port snooping²¹ and connection steering Multiple standard and Enterprise MIBs²² Text-based command-line interface based on familiar router interface Standard Cisco IOS security capabilities: password and TACACS,²³ Telnet, TFTP²⁴, BOOTP, LAN Emulation client, RFC²⁵ 1577 Classical IP over ATM client (for management access)
MIBs	SNMP MIB II (RFC 1213) Interface table MIB (RFC 1573) AToM MIB (RFC 1695) ATM Forum PNNI 1.0 MIB ATM Forum UNI 3.0/3.1 ILMI²⁶ 4.0 MIB
Agency Approvals	Safety: UL ²⁷ 1950, CSA-C22.2 ²⁸ No. 950, EN60950, IEC950 ²⁹, TS001 EMI ³⁰: FCC Part 15 Class A, Canadian ICES-003 Class A, CE Masking, EN55022 Class A, VCCI Class III, CISPR A with UTP, EN55022 Class B, CISPR Class B, VCCI Class II with shielded cables

¹PNNI = Private Network-Network Interface.
² MIPS = MultiChannel Interface Processor.
³DRAM = dynamic random-access memory.
⁴FC-PCQ = feature card per-class queueing.
⁵FC-PFQ = feature card per-flow queueing.
⁶EPROM = erasable programmable read-only memory.
⁷SRAM = static random-access memory.
⁸PCMCIA = Personal Computer Memory Card International Association.
⁹EIA/TIA = Electronic Industries Association/Telecommunications Industry Association.
¹⁰VC = virtual channel.
¹¹VP = virtual path.
¹²PVC = permanent virtual circuit.
¹³SVC = switched virtual circuit.
¹⁴OAM = Operations, Administration, and Maintenance.
¹⁵RDI = remote defect identification.
¹⁶AIS = alarm indication signal.
¹⁷IEEE = Institute of Electrical and Electronics Engineers.
¹⁸TX = transmit.
¹⁹RX = receive.
²⁰LEDs = light emitting diodes.
²¹FC-PFQ supports per-VC, per-VP, and per-port snooping.
²²MIBs = Management Information Bases.
²³TACACS = Terminal Access Control Access System.
²⁴TFTP = Trivial File Transfer Protocol.
²⁵RFC = Request For Comments.
²⁶ILMI = Interim Local Management Interface.
²⁷ UL = Underwriters Laboratory.
²⁸CSA = Canadian Standards Association.
²⁹IEC = International Electrotechnical Commission.
³⁰EMI = electromagnetic interference.

Table of Contents

ASP Specifications