This sample configuration shows a Cisco 827 Digital Subscriber Line (DSL) Router that has been configured with AAL5SNAP and routes IP to a Cisco 6400 Universal Access Concentrator (UAC).
For more information on document conventions, see the Cisco Technical Tips Conventions.
There are no specific prerequisites for this document.
The information in this document is based on the software and hardware versions below.
Cisco 827-4V Customer Premises Equipment (CPE) IOS® Software Release 12.1(1)XB
Cisco 6400 UAC-NRP IOS Software Release 12.0(7)DC
Cisco 6400 UAC-NSP IOS Software Release 12.0(4)DB
Cisco 6130 DSLAM-NI2 IOS Software Release 12.1(1)DA
The information presented in this document was created from devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If you are working in a live network, ensure that you understand the potential impact of any command before using it.
In this section, you are presented with the information to configure the features described in this document.
This document uses the network setup shown in the diagram below.
This document uses the configurations shown below.
Current configuration: ! version 12.1 no service pad service timestamps debug datetime msec service timestamps log datetime msec ! hostname R1 ! ip subnet-zero ! interface Ethernet0 ip address 10.0.0.1 255.0.0.0 no ip directed-broadcast no ip mroute-cache ! interface ATM0 ip address 172.18.0.1 255.255.0.0 no ip directed-broadcast no ip mroute-cache no atm ilmi-keepalive pvc 4/100 protocol ip 172.18.0.2 encapsulation aal5snap ! bundle-enable hold-queue 224 in ! ip classless ip route 0.0.0.0 0.0.0.0 172.18.0.2 no ip http server ! ! voice-port 1 timing hookflash-in 0 ! voice-port 2 timing hookflash-in 0 ! voice-port 3 timing hookflash-in 0 ! voice-port 4 timing hookflash-in 0 ! end
Current configuration: ! version 12.0 no service pad service timestamps debug datetime msec service timestamps log datetime msec hostname NRP ! redundancy main-cpu no auto-sync standard no secondary console enable ip subnet-zero interface ATM0/0/0 no ip address no ip directed-broadcast no ip mroute-cache no ATM ilmi-keepalive ! interface ATM0/0/0.4 point-to-point ip address 172.18.0.2 255.255.0.0 no ip directed-broadcast no ip mroute-cache PVC 4/100 protocol ip 172.18.0.1 encapsulation aal5snap ! interface Ethernet0/0/1 no ip address no ip directed-broadcast ! interface Ethernet0/0/0 no ip directed-broadcast ! interface FastEthernet0/0/0 no ip address no ip directed-broadcast full-duplex ! ip classless ip route 10.0.0.1 255.255.255.255 172.18.0.1 ! end
There is currently no verification procedure available for this configuration.
There is currently no specific troubleshooting information available for this configuration.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.