This document describes one of the reasons why the Cisco ONS 15305 can generate an inventory failure error message, and provides the solution.
Cisco recommends that you have knowledge of these topics:
Cisco ONS 15305
Cisco Edge Craft
The information in this document is based on these software and hardware versions:
Cisco ONS 15305 Software Release 1.1.0
Cisco Edge Craft Software Release 1.1
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
A bank is a memory location in Cisco ONS 15305 where software and firmware are stored.
There are two banks. One stores the running software, and the other stores the backup software version. The backup software version can either be newly loaded software that awaits to be made active, or can be existing system software.
After you install an AC 230V power module on a Cisco ONS 15305 that runs Software Release1.0.0, an inventory failure error message appears (see figure 1). The problem persists even if you upgrade to Software Release 1.1.0. The error message still appears.
Note: Release 1.1.x and later support the AC 230V power module.Figure 1 – Inventory Failure Error Message
Load ONS 15305 Release 1.1.0 after you install the 230V module. Release 1.1.0 contains system control software files, which end with .bin. Release 1.1.0 also contains a network release file which ends with .def (see figure 2).Figure 2 – ONS 15305 Release 1.1.0 Files
In order to successfully upgrade from Release 1.0.0 to 1.1.0, you must load both types of file to the Cisco Edge Craft tool from the TFTP server with the help of the procedure in this document. The Release Notes for Release 1.1.0 also outlines this procedure.
Note: You must follow the correct sequence.
Complete these steps in order to load ONS 15305 Release 1.1.0:
Download the System Controller software (45004-77xx_PM_EDnn.bin).
Switch the bank, and reboot.
Download the complete Network Release (55004-01xx_PM_EDnn.def).
Switch the bank and reboot.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.