Document ID: 12660
Updated: Jan 31, 2006
Contents
Introduction
This document describes how to change the sendmail IP address on the Cisco Content Services Switches (CSS).
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
-
Cisco CSS 11000 and 11500 series
-
Cisco WebNS Software Version 2.06 and later
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Information
The sendmail module in the CSS uses the management IP address as the
sender. At this time, this setup is not configurable. The default management IP
address for the CSS 11000 is 1.1.1.1. By default, the CSS 11500 configuration
does not include a management address. If you have more than one CSS, it is advised
that youmake the management IP addresses unique. To change the management
IP address, issuee following:
config
boot
ip address x.x.x.x
reboot
Here is an example message:
From: 1.1.1.1 [mailto:1.1.1.1] Sent: None Subject: Log Message from 1.1.1.1: Alert error
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.