Document ID: 12642
Updated: Dec 27, 2007
Contents
Introduction
This document provides information on rerunning the setup script on the CSS 11000 and 11500 series content services switches.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document applies to:
-
all CSS 11000 and 11500 series content services switches
-
Cisco WebNS Software Release 2.06 and later
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Information
The setup script runs the first time the CSS is booted. If there is no saved startup-config or archived startup-config, the CSS runs the setup script.
If you would like to rerun the setup script, you can perform one of these actions:
-
Clear the running config and issue the script play setup command.
-
Issue the clear startup-config and clear archive startup-config commands. Reboot the switch
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.