This document shows you how to upgrade a Cisco Content Engine 507 from CDN Software Enterprise Solution Release 2.0, or earlier, to 2.1, or later.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
If your Content Engine was part of your network, but the Content Distribution Manager (CDM) was upgraded without the Content Engine, these instructions allow you to manually upgrade the software.
If your Content Engine has never been connected to the registry and the rest of your system runs release 2.1, call the Cisco Technical Assistance Center (TAC) for assistance.
Note: If your Content Engine had a MANUAL_UPGRADE channel with release 2.1 in it, go to steps 4-7 after entering this information:
cp /sonoma/state/cache/*image-name.upg.* /sonoma/state/ftp/export/cdn-enterprise-2.1.upg
Complete these steps:
Turn on the Content Engine. Make sure you have a console connection.
Log in to the console as root. The default password is default.
Stop the Sonoma software.
Configure the Ethernet interface.
ifconfig eth0 ip-addr netmask mask broadcast bcast route add 0.0.0.0/0 gw gateway-address
Clean and mount the filesystems.
fsck /sonoma/sys fsck /sonoma/state mount /sonoma/sys mount /sonoma/state
Copy the upgrade image to /sonoma/state/ftp/export.
cd /sonoma/state/ftp/export ftp ftpserver-address binary prompt hash get cdn-enterprise-2.1.upg bye
Set the date.
date mmddhhmmyyyy (MonthDayHourMinuteYear)
Upgrade the software.
Reboot the Content Engine.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.