Table Of Contents

P

parameter (ccn application)

P

---

parameter (ccn application)

parameter (ccn application)

To set the value for a CCN application parameter, use the parameter command in Cisco Unity Express configuration application mode. This command does not have a no form.

parameter parameter-name "value"

Syntax Description

parameter-name	Specifies the parameter whose value is being set. These parameters are specified in the application script.
"value"	Specifies the value for the parameter. The value must be entered within double quotes.

Command Modes

Configuration application

Command History

Cisco Unity Express Release	Modification
1.0	This command was introduced on the Cisco Unity Express network module and in Cisco CallManager Express 3.0.
1.1	This command was implemented on the advanced integration module (AIM) and in Cisco CallManager 3.3(3).
1.1.2	This command was implemented on the Cisco 2800 series and Cisco 3800 series routers.

Usage Guidelines

Use the parameter command to change or set the value of an application parameter.

Examples

The following examples sets the value of the MaxRetry parameter to 6:

se-10-0-0-0# config t

se-10-0-0-0(config)# ccn application autoattendant

se-10-0-0-0(config-application)# parameter MaxRetry "6"

se-10-0-0-0(config-application)# end

se-10-0-0-0(config)# exit

Related Commands

Command	Description
ccn application	Configures the CCN applications, such as voice mail and auto attendant.
show ccn application	Displays the CCN application details.