Feedback
|
Table Of Contents
Installation Options for the Cisco UC320W
Optional Power Cord Retention Kit
Installation Options for the Cisco UC320W
September 2011
This document provides instructions about the following installation options:
•
Optional Power Cord Retention Kit
Wall Mounting
Recommended hardware (not included): #6 (0.1380 in. diameter) pan-head tapping screws, 3/4-in. (19mm), with anchors for sheet rock installation.
STEP 1
Drill the holes as shown.
Horizontal Orientation:
Vertical Orientation
STEP 2
Insert the screws, leaving a gap of 4mm between the screw head and the wall. Then mount the UC320W as shown.
Horizontal Orientation
Vertical Orientation
Optional Power Cord Retention Kit
Optionally, you can install the power cord retention kit to prevent accidental removal of the power cord.
STEP 1
Remove the screw next to the power port.
STEP 2
Ensure that the power cord is firmly connected to the power port.
STEP 3
Clip the power cord retention clamp to the power cord, about 10 to 12 inches from the connector.
STEP 4
Position the clamp against the rear panel of the unit, and install the screw, as illustrated below.
Where To Go From Here
Cisco provides a wide range of resources to help you and your customer obtain the full benefits of the Cisco UC320W.
Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks can be found at www.cisco.com/go/trademarks. Third party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1005R)
© 2011 Cisco Systems, Inc. All rights reserved.
78-20408-01
Feedback




