Unified CCE Remote Agent Option with IP Phone is supported on the
Unified CCE, the Unified CCH, and Cisco Unified Contact Center Express
Provision the remote agent PC and IP Phone on the Unified CCE
central site to ensure operability
before distributing it to a remote agent site.
At a remote agent site, connect the agent desktop to the RJ45 port
on the back of the IP Phone.
The IP Phone and agent desktop PC get their network settings
Create a DNS entry for the remote agent desktop; otherwise, an
agent cannot connect to a CTI server.
You can dynamically update or enter DNS entries.
Configure the agent desktop PC at the remote site with an IP
address, network mask, DNS, and default gateway configured for DHCP.
Make sure the 7960 IP Phone has a power supply. (The Cisco 8xx
Series Router cannot supply power to the IP Phone.)
Critical remote agents must have a backup power supply. The backup
power supply must be able to power a PC, an 831 Router, a broadband modem, and
an IP Phone.
Remote agent with IP phone network requirements checklist
Ensure the ADSL and Cable bandwidth values are set to at
least 256 kb uplink and 1 Mbps downlink.
Do not exceed 60 ms to 90 ms of jitter delay each way on the
maximum ADSL network delay. If the ADSL delay is greater than the maximum, the
IPCC application encounters longer response times.
Make sure the Unified CCE bandwidth value does not exceed
128 k uplink; otherwise, the remote agent solution might not work properly.
The default codec for 256 kb uplink is the G.729. To achieve
higher voice quality, use the G.711.
Only unicast Music on Hold (MoH) streams are supported.
Set up a transcoder to enable outside callers to receive
MoH, if the MoH server is not set up to stream G.729 codec.
As a backup to the remote agent desktop, you can configure
the remote agent to use the IP Phone as a login device when possible.
Remote agent with IP phone considerations
IP Phones supported with Unified CCE Remote Agent Option are those
currently compatible with IPCC as listed in the
Hardware & System Software Specification (Bill of Materials)
for Cisco Unified ICM/Contact Center Enterprise & Hosted, Release