Contents

• SNMP system group configuration
• Configure MIB2 system group
• MIB2 system group configuration settings

SNMP system group configuration

---

Cisco Unified Serviceability provides the MIB2 System Group Configuration window where you can configure the system contact and system location objects for the MIB-II system group. For example, you could enter Administrator, 555-121-6633, for the system contact and San Jose, Bldg 23, 2nd floor, for the system location. This chapter contains information on the following topics:

• Configure MIB2 system group
• MIB2 system group configuration settings

Configure MIB2 system group

Perform the following procedure to configure a system contact and system location for the MIB-II system group.

Tip	This procedure supports SNMP v1, v2c, and v3 configuration.

Procedure

---

Step 1	Choose SNMP > SystemGroup > MIB2 System Group.
Step 2	Configure the settings, as described in MIB2 System Group configuration settings.
Step 3	Click Save.
Step 4	A message indicates that changes will not take effect until you restart the SNMP master agent. To continue the configuration without restarting the SNMP master agent service, click Cancel. To restart the SNMP master agent service, click OK. Note    To clear the System Contact and System Location fields, click Clear All. To delete the system configuration, click Clear All and Save.

---

MIB2 system group configuration settings

The table below describes the MIB2 System Group configuration settings.

Table 1 MIB2 System Group configuration settings

Field	Description
Server	From the drop-down list box, choose the server for which you want to configure contacts; then, click Go.
System Contact	In the field, enter a person to notify when problems occur.
System Location	In the field, enter the location of the person that is identified as the system contact.
Unified CM clusters only: Apply To All Nodes	To apply the system configuration to all of the nodes in the cluster, check the check box.