Wall Mount Components for Cisco Unified IP Phone 6901
The following section describes how to install the Wall Mount plate for use with the Cisco Unified IP Phone 6901.
Cisco recommends that you use the Leviton Wall Mount plate (Leviton type number: 4108W-0SP) for mounting the Cisco Unified IP Phone 6901. The wall mount plate must be ordered separately from the phone.
The following figure and table show a list of items required to mount the Cisco Unified IP Phone 6901 on the wall using the Leviton Wall Mount plate.
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular telephone jack. For more information on phone installation requirements and warnings, see Cisco Unified IP Phone installation.
To install the phone on the wall, perform these steps:
Mount the wall bracket in the desired location. You can install
the wall bracket over an Ethernet jack, or you can run the Ethernet network
cable to a jack nearby.
Use the level to ensure the wall bracket is level, then use a
pencil to mark the screw holes.
Using a #2 Phillips-head screwdriver, carefully center the
anchor over the pencil mark and press the anchor into the wall to make markings
on the wall.
Screw the anchor clockwise into the wall until it is seated
Use the included screws and a #2 Phillips-head screwdriver to
attach the wall bracket to the wall.
Figure 7. Mounting the Wall Bracket
Attach the phone bracket to the IP Phone.
Detach the handset cord (and headset cord, if there is a
headset), power cord, and any other attached cords from the base of the phone.
Remove the label covers that are concealing the screw holes.
Attach the phone bracket by inserting the tabs into the
mounting tabs on the phone. The phone ports should be accessible through the
holes in the bracket.
Secure the phone bracket to the IP Phone with the
Thread the handset cord (and headset cord, if using one).
Reattach the cords and seat them in the clips incorporated into the phone body.
Figure 8. Attaching the Phone Bracket
Attach the Ethernet cable to the 10/100 SW network port and wall
If you are connecting a network device (such as a computer) to the
phone, attach the cable to the 10/100 PC access port.
If you are using an external power supply, plug the power cord
into the phone and dress the cord by clipping it into the clips incorporated
into the phone body next to the 10/100 PC port.
Figure 9. Attaching the Cables
Attach the phone to the wall bracket by inserting the tabs on the
top of the phone bracket into the slots on the wall bracket. Ensure that the
power cord and any other cable that does not terminate in the wall behind the
bracket are positioned in one of the cable-access openings in the bottom of the
bracket. The phone and wall bracket openings together form circular openings
with room for one cable per opening.
Use the locking key to lock the phone to the wall bracket.
Figure 10. Attaching the Phone to the Wall Bracket
With a wall-mounted phone, you might need to adjust the handset rest to ensure that the receiver does not slip out of the cradle. The hook should have a lip on which the handset catches when the phone is vertical. Follow the diagram and steps below to change the hookswitch hook.
Figure 11. Adjust the Handset Hook
Remove the handset from the cradle and pull the plastic tab from the handset rest.
Rotate the tab 180 degrees.
Hold the tab between two fingers, with the corner notches facing you.
Line up the tab with the slot in the cradle, and press the tab evenly into the slot. An extension protrudes from the top of the rotated tab. Return the handset to the handset rest.