Use Microsoft Internet Explorer version 6.0 or a later release,
or Mozilla Firefox version 3.0 or a later release to access the Cisco Unified IM and Presence Operating System Administration
interface. Other browsers are not supported.
Sign in to Cisco Unified IM and Presence Operating System Administration
Before You Begin
If you are currently signed in to
Cisco Unified CM IM and Presence Administration, sign out before proceeding.
Navigation > Cisco
Unified IM and Presence OS Administration from the menu in the upper,
right corner of the
Cisco Unified CM IM and Presence Administration window.
Enter your Administrator username and password.
You can also access
Cisco Unified IM and Presence Operating System Administration directly by entering the following URL:
The Administrator username and password are established during
installation or created using the command line interface.
Recover Administrator password
If you lose the Administrator password and cannot access the
system, you can reset the Administrator password.
Before You Begin
During this procedure, you will be required to remove and then insert a valid CD or DVD in the disk drive to prove that you have physical access to the system.
At any point, when requested to insert CD or DVD media, it should be mounted through vSphere client for VMWare server.
The Administrator sign-in
must start with an alphabetic character, be at least six characters long, and
can contain alphanumeric characters, hyphens, and underscores.
You will be required to remove, then insert, any valid CD or DVD media through the VMWare-vSphere client. To begin, you must remove any media from the VMWare client CD/DVD drive. You may press Control-C at any time to abort.
Sign in to the system with the following username and password:
Press any key when ready.
If you have a valid CD or DVD in the disk drive, remove it from the VMWare client CD or DVD drive now.
Press any key to continue.
The system tests to ensure that you have removed the CD or DVD
from the VMWare client drive.
You may press Control-C at any time to abort.
Connect the CD or DVD drive from WMWare client and press any key when ready.
Insert a valid CD or DVD into the VMWare client drive.
After the system verifies that you have inserted the disk, you are
prompted to enter a new Administrator password.
Reenter the new password.
After the system verifies the strength of the new password, the
password is reset, and you are prompted to press any key to exit the password
During the VMWare pwrecovery/pwreset, if you do not strictly follow the instruction, a few of errors may occur but they can be ignored.
If you want to set up a different Administrator password, use
the CLI command
See the Command Line Interface Reference Guide for Cisco Unified
Solutions for more information.
The system checks the new password that you enter for
strength. If the password does not contain enough different characters, you are
prompted to enter a new password.
Create customized log-on message
You can upload a text file that contains a customized log-on
message that appears in each of the
IM and Presence Service applications administrative interfaces.
Sign in to Cisco Unified IM and Presence Operating System