Table Of Contents

Brooktrout Technology TR114+P4L and TR114+uP4L PCI Voice-Fax Cards

Brooktrout Technology TR114+P4L and TR114+uP4L PCI Voice-Fax Cards

---

The TR114+P4L and TR114+uP4L voice-fax cards provide four loop-start lines for inbound or outbound messages. The cards are installed in the Bridge server, and both types of cards can be installed in the same Bridge server.

The TR114+P4L and TR114+uP4L cards have one RJ-45 receptacle serving all four ports. The line cord that ships with most cards has an RJ-45 connector on one end and four single-pair RJ-11 connectors on the other end. For the United Kingdom and for Hong Kong, the line cord that ships with the cards has an RJ-45 connector on one end and four single-pair BT-431A connectors on the other end.

Universal PCI (uPCI) is the ability to plug a TR114+uP4L card into either a 3.3-volt or 5-volt bus slot in a server chassis. A uPCI card is physically keyed for both 3.3-volt and 5-volt bus signaling, and has a second notch in the PCI edge connector on the card.

The TBR-21-compliant TR114+P4L and TR114+uP4L cards are qualified for use in Europe, and other country-specific TR114+P4L and TR114+uP4L cards have also been qualified. For a complete list of qualified cards, refer to the "Supported Voice-Fax Cards" section of Cisco Unity Bridge 2.1 System Requirements, and Supported Hardware and Software, available on Cisco.com at http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_pre_installation_guides_list.html.

Figure A-1 shows the top and side views of theTR114+P4L card, Figure A-2 shows the top and side views of the TR114+uP4L card, and Figure A-3 shows the connection pinouts and back plate for both cards.

Figure A-1 TR114+P4L Top and Side Views

Figure A-2 TR114+uP4L Top and Side Views

Figure A-3 TR114+P4L and TR114+uP4L Connection Pinouts and Back Plate