Table Of Contents

Brooktrout Technology TR114+P4L PCI Analog Voice-and-Fax Card

Hardware Settings

Brooktrout Technology TR114+P4L PCI Analog Voice-and-Fax Card

---

The TR114+P4L voice-and-fax card provides four loop-start lines for inbound or outbound messages. The card is installed in the Cisco Unity Bridge server.

The TR114+P4L voice-and-fax card has one RJ-45 receptacle serving all four ports. The line cord that ships with the card has an RJ-45 connector on one end and four single-pair RJ-14 connectors on the other end.

Figure A-1 TR114+P4L PCI Analog Top and Side Views

Figure A-2 TR114+P4L PCI Analog Connection Pinouts and Backplate

Hardware Settings

All TR114+P4L voice-and-fax cards share address IRQ 10. Because Brooktrout PCI analog voice-and-fax cards are designed for the PCI expansion bus, the interrupts and memory (I/O) addresses used by the cards are assigned by the platform BIOS, not by configuring jumpers or switches.

Refer to the Bridge server hardware documentation to determine how to configure the platform to assign IRQ 10 to expansion slots used by PCI voice-and-fax cards.