My Cisco acquired Codian/TANDBERG product does not send HD resolutions to my Cisco TelePresence System MXP endpoint when the Motion/sharpness trade off is set to Balanced. What shall I do?
To send 720p 30fps to MXPs, set your Cisco acquired Codian/TANDBERG product's Motion / sharpness tradeoff to Favor sharpness or configure your MXPs as pre-configured endpoints with the Motion / sharpness tradeoff set to Favor sharpness.
For more information about pre-configuring endpoints, refer to the online help topic, Configuring H.323 endpoints.
This article applies to the following products:
- Cisco TelePresence MCU 4200 / MSE 8420
- Cisco TelePresence MCU 4500
- Cisco TelePresence MSE 8510 blade
- Cisco TelePresence Advanced Media Gateway 3600
| May 2nd, 2011 | TAA_KB_117 |