Configuring Internal Power Supplies

Configuring Internal Power Supplies

This module contains the following sections:

How to Configure Internal Power Supplies

Configuring an Internal Power Supply

You can use the power supply EXEC command to configure and manage the internal power supply on the switch. The switch does not support the no power supply EXEC command.

SUMMARY STEPS

    1.    power supply switch_number frufep{A | B} { off | on }

    2.    show environment power


DETAILED STEPS
     Command or ActionPurpose
    Step 1 power supply switch_number frufep{A | B} { off | on }


    Example:
    Switch> power supply 1 frupfep A on 
    
    
     

    Sets the specified power supply to off or on by using one of these keywords:

    • A —Selects the power supply in slot A.
    • B —Selects power supply in slot B.
      Note   

      Power supply slot B slot is the closest to the outer edge of the switch.

    • off —Set the power supply off.
    • on —Set the power supply on.

    By default, the switch power supply is on.

     
    Step 2show environment power


    Example:
    Switch> show environment power
    
    
     

    Verifies your settings.

     

    Monitoring Internal Power Supplies

    Table 1 Show Commands for Power Supplies

    Command

    Purpose

    show environment power [ all | switch switch_number ]

    (Optional) Displays the status of the internal power supplies for each switch in the stack or for the specified switch. The range is 1 to 9, depending on the switch member numbers in the stack.