Table Of Contents

Unsupported CLI Commands in Release 12.1(11)AX

Access Control Lists

Unsupported Privileged EXEC Commands

Unsupported Global Configuration Commands

Unsupported Debug Commands

Interface Commands

Unsupported Privileged EXEC Commands

Unsupported Global Configuration Commands

Unsupported Interface Configuration Commands

RADIUS

Unsupported Global Configuration Commands

SNMP

Unsupported Global Configuration Commands

Spanning Tree

Unsupported Global Configuration Commands

Unsupported Interface Configuration Commands

VLAN

Unsupported vlan-config Commands

Unsupported User EXEC Commands

VTP

Unsupported Privileged EXEC Commands

Unsupported CLI Commands in Release 12.1(11)AX

---

This appendix lists some of the command-line interface (CLI) commands that are displayed when you enter the question mark (?) at the Catalyst 2970 switch prompt but are not supported in this release, either because they are not tested, or because of Catalyst 2970 hardware limitations. This is not a complete list. The unsupported commands are listed by software feature and command mode.

Access Control Lists

Unsupported Privileged EXEC Commands

access-enable [host] [timeout minutes]

access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]

clear access-template [access-list-number | name] [dynamic-name] [source] [destination].

Unsupported Global Configuration Commands

access-list rate-limit acl-index {precedence | mask prec-mask}

access-list dynamic extended

Unsupported Debug Commands

debug platform cli-redirection main

debug platform configuration

Interface Commands

Unsupported Privileged EXEC Commands

show interfaces [interface-id | vlan vlan-id] [capabilities | crb | fair-queue | irb | mac-accounting | precedence | irb | random-detect | rate-limit | shape]

Unsupported Global Configuration Commands

interface tunnel

Unsupported Interface Configuration Commands

switchport broadcast level

switchport multicast level

switchport unicast level

---

Note These commands have been replaced by the storm-control {broadcast | multicast | unicast} level level [.level] interface configuration command.

---

RADIUS

Unsupported Global Configuration Commands

aaa nas port extended

radius-server attribute nas-port

radius-server configure

radius-server extended-portnames

SNMP

Unsupported Global Configuration Commands

snmp-server enable informs

Spanning Tree

Unsupported Global Configuration Commands

spanning-tree etherchannel guard misconfig

no spanning-tree mode

spanning-tree pathcost method {long | short}

Unsupported Interface Configuration Commands

spanning-tree link-type {point-to-point | shared}

spanning-tree stack-port

VLAN

Unsupported vlan-config Commands

private-vlan

Unsupported User EXEC Commands

show vlan ifindex

show vlan private-vlan

VTP

Unsupported Privileged EXEC Commands

vtp {password password | pruning | version number}private-vlan

---

Note This command has been replaced by the vtp global configuration command.

---