This chapter describes the Cisco NX-OS system management commands that begin with the letter B.
blink
To blink the LED on the system, use the blink command. To restore the default LED state, use the no form of this command.
Note Beginning with Cisco NX-OS Release 4.1(2), the blink command is not available in Cisco NX-OS software. Use the locator-led command for this function.
Use the blink command to flash the LED on a component in the system. You can use this blinking LED to identify the component to an administrator in the data center.
This command does not require a license.
Examples
This example blinks the LED for module 4:
switch# blink module 4
Related Commands
Command
Description
show locator-led status
Displays the status of locator LEDs on the system.