Table Of Contents
N Commands
This chapter describes the Cisco NX-OS Multiprotocol Label Switching commands that begin with N.
neighbor
To configure neighbor parameters, use the neighbor command. To return to the default setting, use the no form of this command.
neighbor ip-address {implicit-withdraw | labels accept prefix-list | targeted}
no neighbor ip-address implicit-withdraw | labels accept prefix-list | targeted}
Syntax Description
Defaults
None
Command Modes
LDP configuration mode
Supported User Rolesnetwork-admin
vdc-adminCommand History
Usage Guidelines
This command requires the MPLS Services license.
Examples
This example shows how to configure the prefix list to be used to filter label bindings for the specified LDP neighbor:
switch# configure terminal
switch(config)# mpls ldp configuration
switch(config-ldp)# neighbor 10.12.12.12 labels accept p1
switch(config-ldp)#Related Commands
Command Descriptionmpls ldp configuration
Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP).