This chapter describes how to configure IP Source
Guard on Cisco NX-OS devices.
The Cisco NX-OS release that is running on a managed device may not
support all the features or settings described in this
chapter. For the latest feature
information and caveats, see the documentation and release notes for your
platform and software release.
IP Source Guard is a per-interface traffic filter that permits IP
traffic only when the IP address and MAC address of each packet matches one of
two sources of IP and MAC address bindings:
Entries in the Dynamic Host Configuration Protocol (DHCP) snooping
Static IP source entries that you configure.
Filtering on trusted IP and MAC address bindings helps prevent spoofing
attacks, in which an attacker uses the IP address of a valid host to gain
unauthorized network access. To circumvent IP Source Guard, an attacker would
have to spoof both the IP address and the MAC address of a valid host.
You can enable IP Source Guard on Layer 2 interfaces that are not
trusted by DHCP snooping. IP Source Guard supports interfaces that are
configured to operate in access mode and trunk mode. When you initially enable
IP Source Guard, all inbound IP traffic on the interface is blocked except for
DHCP packets, which DHCP snooping inspects and then forwards or
drops, depending upon the results of inspecting the packet.
IP traffic from static IP source entries that you have configured in
the Cisco NX-OS device.
The device permits the IP traffic when DHCP snooping adds a binding
table entry for the IP address and MAC address of an IP packet or when you have
configured a static IP source entry.
The device drops IP packets when the IP address and MAC address of the
packet do not have a binding table entry or a static IP source entry. For
example, assume that
the binding table
contains the following entry:
If the device receives an IP packet with an IP address of 10.5.5.2, IP
Source Guard forwards the packet only if the MAC address of the packet is
Licensing Requirements for IP Source Guard
This table shows the licensing requirements for IP Source Guard.
IP Source Guard requires a LAN Enterprise license. For an explanation of the Cisco DCNM licensing scheme and how to obtain and apply licenses, see the Cisco DCNM Installation and Licensing Guide, Release 5.x.
IP Source Guard requires no license. Any feature not included in a license package is bundled with the Cisco NX-OS system images and is provided at no extra charge to you. For an explanation of the Cisco NX-OS licensing scheme for your platform, see the licensing guide for your platform.
Prerequisites for IP Source Guard
The following prerequisites are required for using this feature on Cisco DCNM. For a full list of feature-specific prerequisites, see the platform-specific documentation.
System-message logging levels for the IP Source Guard feature must meet or exceed Cisco DCNM requirements. During device discovery, Cisco DCNM detects inadequate logging levels and raises them to the minimum requirements. Cisco Nexus 7000 Series switches that run Cisco NX-OS Release 4.0 are an exception. For Cisco NX-OS Release 4.0, prior to device discovery, use the command-line interface to configure logging levels to meet or exceed Cisco DCNM requirements. For more information, see the .
Platform Support for IP Source Guard
The following platform supports this feature. For platform-specific information, including guidelines and limitations, system defaults, and configuration limits, see the corresponding documentation.