Table Of Contents

R Commands

restart igmp

restart msdp

restart pim

restart pim6

R Commands

---

This chapter describes the Cisco NX-OS multicast routing commands that begin with R.

restart igmp

To restart the IGMP process, use the restart igmp command.

restart igmp

Syntax Description

This command has no arguments or keywords.

Defaults

None

Command Modes

Any command mode

Supported User Roles

network-admin
network-operator
vdc-admin
vdc-operator

Command History

Release	Modification
4.0(1)	This command was introduced.

Usage Guidelines

This command does not require a license.

Examples

This example shows how to restart the process:

switch(config)# restart igmp

Related Commands

Command	Description
ip igmp flush-routes	Enables flushing routes when the IGMP process is restarted.

restart msdp

To restart the Multicast Source Discovery Protocol (MSDP) process, use the restart msdp command.

restart msdp

Syntax Description

This command has no arguments or keywords.

Defaults

None

Command Modes

Any command mode

Supported User Roles

network-admin
network-operator
vdc-admin
vdc-operator

Command History

Release	Modification
4.0(1)	This command was introduced.

Usage Guidelines

This command requires the Enterprise Services license.

Examples

This example shows how to restart the MSDP process:

switch(config)# restart msdp

Related Commands

Command	Description
ip msdp flush-routes	Enables flushing routes when the MSDP process is restarted.

restart pim

To restart the IPv4 Protocol Independent Multicast (PIM) process, use the restart pim command.

restart pim

Syntax Description

This command has no arguments or keywords.

Defaults

None

Command Modes

Any command mode

Supported User Roles

network-admin
network-operator
vdc-admin
vdc-operator

Command History

Release	Modification
4.0(1)	This command was introduced.

Usage Guidelines

This command requires the Enterprise Services license.

Examples

This example shows how to restart the PIM process:

switch(config)# restart pim

Related Commands

Command	Description
ip pim flush-routes	Enables flushing routes when the PIM process is restarted.

restart pim6

To restart the IPv6 Protocol Independent Multicast (PIM6) process, use the restart pim6 command.

restart pim6

Syntax Description

This command has no arguments or keywords.

Defaults

None

Command Modes

Any command mode

Supported User Roles

network-admin
network-operator
vdc-admin
vdc-operator

Command History

Release	Modification
4.0(1)	This command was introduced.

Usage Guidelines

This command requires the Enterprise Services license.

Examples

This example shows how to restart the PIM6 process:

switch(config)# restart pim6

Related Commands

Command	Description
ipv6 pim flush-routes	Enables flushing routes when the PIM6 process is restarted.